GoodBelkisGood support piece5
Necessary when using legsEmilioThis hidden leg is necessary when using a BESTA in horizontal position with legs. This relieves pressure from the cabinet preventing it from arching.
It comes with one wood screw. The other side attaches to the pre-built hole on the BESTA cabinet.
Make sure to adjust the foot so it's leveled with the legs.5
Holds it upLawrenceMake sure you have at least one for the Besta unit. Supports the center of the cabinet when using the optional legs. 5
Useless NicoleI have slid my unit a few times approximately three feet back and forth to clean and now the metal Besta leg is bent. It has become useless. I should have purchased another set of legs to use one for the middle support. 1
Not supportive enoughLauren T.Easy to install on the Besta cabinet just don't expect it to last, especially if you have a TV on the cabinet or anything remotely substantial stored inside it. The whole cabinet started bowing after only a little while and it just keeps getting more noticeable especially since it throws off the door alignment. After only a couple years so I will need to swap to the low legs or find another solution.2
GoodAlberto M.Good.5
Does it's jobVerified BuyerDoes it's job5
Jury is still outErnestI installed them and made adjustments. Although, my home is relatively new, less than five years old, the floors are not precisely level, I decided to uninstall them because it only emphasized the console needs to be bolted to the wall. Right now, I have the console still on the floor using the “flat” or default legs. When I get the time to revisit properly mounting my console up to my liking, finding a wall stud, I will tackle using this or not. I am in no rush.3
Easy to installMikeWorks great5
would have preferred they matchedMarywould have preferred they matched the legs in appearance4
LOVE! LOVE! LOVE!!!WilliamLOVE! LOVE! LOVE!!!5
Doesn't fitKennethThis piece doesn't fit the two-unit Bestå TV shelf that it was sold with. The better option is to just buy two extra feet to go in the middle of the shelf.2
What is this for--PatriciaThe instructions for assembling this cabinet did NOT fully show, explain, or give steps/options on how to use this and other pieces ...1
Necessary when using legsEmilioThis hidden leg is necessary when using a BESTA in horizontal position with legs. This relieves pressure from the cabinet preventing it from arching.
It comes with one wood screw. The other side attaches to the pre-built hole on the BESTA cabinet.
Make sure to adjust the foot so it's leveled with the legs.5
ExcellentJuanExcellent5
Works!StephenWorks!5
Great productHarithaGreat product1
Nothing wrong with it but...Verified Buyer...it turns out it doesn't fit the particular piece I have, and there was no way to tell that from the website.1
Cool way to make part of your BESTÅ cabinets “float”LeeI used the BESTÅ online designer to design a large office organizer. I couldn’t be happier with the outcome!
This support leg can support the center of an wide cabinet and makes it look like that section has not support. It’s a easy way to customize your BESTÅ caninet’s look.4
Easy install!ErwynBought this for a sagging IKEA TV cabinet that was long and narrow. Did the job and corrected the sagging and door alignment.5